Maxtrac Radius 9600 Baud Packet Conversion

9600 Baud Packet Conversion
The Maxtrac/Radius Series are 9600 baud packet capable. They do need a minor modification though. For RX, its no big deal, just take RX audio from PIN 11 of the Accessory Connector and swing JU551 to the (A) position (Flat RX Unmuted). For TX audio, you will have to run a jumper to the junction of R223, C228, R222 on the RF board to inject the data (if applicable you may need to set the deviation pot in the radio to maximum). You might want to put a pot on your TX line somewhat like the setup Motorola uses (voltage divider) to adjust the deviation. It would be wise to do some measurements to make sure you have the deviation correct. You might also want run the RX and TX pins to the unused pins on the front mic connector after the mods are done.